LED PCB

Characteristic

Make "slit" by high accurate press-cut method, which gives good effects to cost reduction and high quality.
Supply 0.06mm thickness material PCB for < 0.4 mm height Chip.
Supply high-brightness and reflector technology for not only current LED, but also white and blue LED.
Supply white color material, which increase reflection ratio and prevent from color change.
Supply very pure Gold plating for bonding.
Can supply MID type PCB, which give capability for three-dimensional design.
Supply good method of heat radiation from Chip.

LED PCB1

LED PCB2

Board thickness	from 0.06 mm to 0.4 mm
Width of "slit"	min 0.6 mm
Plating	Electric and bondable Gold (min Ni 5 microns, Au 0.3 microns) -High luster, middle luster, no luster Electroless and bondable thin Gold (min Ni 5 microns, Au 0 .03 microns) Electroless and bondable thick Gold (min Ni 5 microns, Au 0.3 microns) Electric Silver (min Ni 5microns,Ag 1 microns) Selective plating to Reflector
Reflector	Supply any shape as customer request
Heat radiation	Copper base , Aluminum base
MID type PCB	Epoxy resin, etc